Showing posts with label tin toys.. Show all posts
Showing posts with label tin toys.. Show all posts

Sunday, October 16, 2016

Morphy Auctions Interesting Toys

Monday, October 17, 2016
Sunny and Cold
13 Celsius  56 Fahrenheit



Morphy Auctions Interesting Toys
(June 24, 2016 Auction)


I'm always looking for new toys. Sometimes, I will visit past auctions of toy auctioneers to see what they auctioned off a while ago. This time however, I was wandering around the Net, when I came across a website called Global Auction Guide. The website is similar to Liveauctioneers in that it promotes new upcoming auctions, as well as keeping old and finished auctions.

The Global Auction Website  had some nice photos of a Morphy Auction that was held on June 24, 2016. I figured that it would be easier to visit the Morphy auction website, but when I did, this particular auction and not to be seen. Obviously, you could only go back in time so much on the Morphy Auction website.

Scarce Early English Tin Litho Whitanco Bus. 
Wind-up. Circa 1920's. Lithographed in maroon, cream, and black with window cut-outs. Rear entrance with stairs. Marked "Toyland Playthings Fairyland Whitanco" on both sides. Has original tin litho driver. Roof needs to be retabbed in. Has some scratching and wear throughout, especially to front hood. Featured in Antique Toy World Article. September 1983 - Page 32. 
Length 14" 355 mm

Scarce English Tin Litho Wind-up Charabank Bus
Made by Whitanco, England Circa 1920. White rubber tires and tin litho driver. Marked
"Whitanco" on rear of toy and also "Made in England -Liverpool". Featured in Antique Toy World Article (October 2009). Length 11" 279 mm


 Spanish Tin Litho Rico Wind-up Amphibian Aircraft
Circa 1930. Four propellers on top.Hull-like fuselage, Marked "Garai" on sides of fuselage.
Size L x wingspan:  14 1/4" x 17 1/2"    368 mm x 444 mm




Italian Ingap Tin Litho Wind-up Balilla Car
Marked "Ingap" on rear. Marked "Superflex IngaP on tin litho wheels.
Circa 1930's
Length:  7 1/2"  190 mm


Techino Tin Litho Rescue Plane
Twin propellers. Pre WWII. Made in Denmark. Has hinged side door and rubber tires. 
Has original Red Cross driver in cockpit.
Length x wingspan:  10 1/4"  x  14"    260 mm x 350 mm


Spanish Tin Litho Wind-up Madrid a Paris Limo Toy
Original tin litho driver. Marked "Berlina" on both sides of rear doors. Made by MJG.
Roof is removable, could have been a candy container. Top sliding roof is a replacement.
Early 20th century, very scarce.
Length:  6"  152 mm


Early European-made Twin Horse Drawn Open Carriage
Late 18th century, probably French. Very Nicely-made, professionally replaced,
Length:  13"  330 mm

 2 Pre-WWII Tin French Racing Cars
One made by Pintel. Unusual front crank fly-wheel mechanism. Original tin litho driver.
The second one is made by S/F. No 3 Racer, push toy.
Largest:  8"  203 mm




Scarce French Tin Litho Lion Noir Delivery Wagon
 Original large lion figure on top which is made of composite material. Push toy.
Length:  6 1/4"   159 mm

If you'd like to visit the Global Auction Website for more toys, please click below:

Please Click Here

I hope that you find this new-found toys interesting, 
and that you'll visit the Global Auction Website for more toys.

Thanks for dropping by,
and always, 
Have a great part of the day or night,
Wherever you may be.

Stacey Bindman
toysearcher@gmail.com

Saturday, October 1, 2016

A George Brown Tin Horse Carriage and Driver

Friday, October 14, 2016
Overcast
15 Celsius / 59 Fahrenheit


A George Brown Tin Horse Carriage and Driver


1880's George Brown Tin Horse Carriage & Driver
Outstanding original paint on this antique tin toy.
Beautiful colour. 
Length:  14"  355.6 mm





I selected this toy because it is rare. Although it did not get a high amount of money for the final bid, 
it was worth presenting it. One hardly sees these toys come up at auction because they are so old.
Nevertheless it's a rare find worth the work to post it.

If you ever see any of these on the Internet or have a George Brown toy, please send me the link or photos. I'm always happy to post on this very old American toy.


Thanks for dropping by,
And as always,
have a great time of the day or night,
Wherever you may be.
Stacey Bindman
toysearcher@gmail.com

Saturday, October 11, 2014

A Dozen Strauss Trucks

Saturday, October 11, 2014
   Sunny and cooler temperatures


A Dozen Strauss Trucks

  I've been writing about lumber (timber) trucks,and for a few of the latest posts had the Struss lumber truck with its trailer. However, if you simply type in "Strauss Truck" rather than "Strauss Timber Truck", all kinds of trucks will show as the search results.  I did this by accident, several times, and corrected myself, but knew I would have today's post for an idea. 

   What's noteworthy is that Strauss made at least 12 of these toy trucks all similar in design and with bold colours and the key wind movement. More interestingly, these toys were made for over a decade (1930's-1940's), so they certainly must have sold very well.


The truck below is a delivery truck and is quite different from the other trucks presented today.
The 3 trucks below are very similar. The main differences are the colour schemes and the titles on the sides of the trucks. Also the sizes are different.



The Strauss Auto Dump Truck below is  slightly;y different with 
the smaller-sized dumpster in the back of the truck.

The Strauss  Tow Truck got larger over a deceased. What I find interesting is that the company stayed with an older-model truck in 1940. What's more interesting is that the newer model 
doesn't have head lights!



Once again, we see the same basic design below. What changes from the 1930's to the 1940's
is that there is a  rear gate that folds down in the 1940's version.



Another type of truck in the Strauss line was the  liquid delivery. There were 2 liquids - water and oil. Here again, you can easily see the similarities between booth the water and the oil delivery trucks. 

The differences are small. The water truck has one filling cap, while the oil has 2 caps.
Smaller differences include the colour themes and the side numbers.

72 for water,  and 73 for the larger oil truck.
The junior-sized truck is smaller, and has no numbers.

Once again notice that the larger trucks don;t have headlights, while the smaller "junior" has them.








There's an old expression that says "if it isn't broken, don;t fix it".
Interpreted, that simply meant that if something worked or was a successful, then don't change it.
In the case of the Strauss trucks, the basic design didn't change much for a deceased, and the designs for most of the trucks, albeit the colour patterns were also similar.

On an assembly line, workers, I'm sure would have been quite proficient and fast at being able to mass produce these toys. Of course, they must have learned from Henry Ford and his assembly line.

Or perhaps they learned, but "altered" from one of his famous lines.

Several years after Mr Ford had proven the  moving assembly line to be very successful, and his Model T Fords rolled off one-after-another very swiftly, Mr. Ford was  asked  a question by a reporter.

"Mr. Ford," the reporter asked. 
"Are you ever going to paint your cars in other colours beside black?
"Yes"  Mr. Ford,  was supposedly heard to have said answered.
Any colour, as long as it is in black".

Thanks for dropping by to visit,
and as always,
have a great part of the day or night,
wherever you may be,
Stacey

Please feel free to write to me anytime at:
toysearcher@gmail.com









Tuesday, June 17, 2014

More Girard Airplanes from OpAmerica - Part II

Tuesday, June 17, 2014
    Sunny, clear, hot and humid


More Girard Airplanes from 
OpAmerica

   If you're a regular reader to my blog, you'll already know that I prefer to give each auctioneer, seller, or collector his/her own exclusive posting. I like doing this because for each one to have his/own post, although I'm sire they wouldn't mind my adding several together.

OpAmerica is a very successful seller on ebay that always has an excellent selection of toys up for bidding. But why like even more are the fine-quality photographs, the numerous different photos, and the excellent descriptions of the toy.







These 2 additional Girard airplanes certainly add nicely to the ones that I presented earlier from Dan Morphy's company. If I had more place, and of course, more $$, I'd have a special room full of antique toys. There's a mystique that I have about "old", and it's always interesting to thing how a toy might have changed hands over a period of 90 years!


Thanks for dropping by,
and as always,
have a great part of the day or night,
wherever you may be.
Stacey.

toysearcher@gmail.com



Thursday, May 8, 2014

A Tale of Two Tow Trucks

  Thursday, May 8, 2014
Sunny and warm , but seasonally cool.


A Tale of Two Tow Trucks

  I saw two nice tow trucks that Ron Michaud from Maine had sold  and decided to compare the two. Ron always seems to have very nice old toys up for sale, and like all the people that help me out, I really appreciate his help. I decided to compare the 2 toys because Mr. Marx had at one time worked for Ferdinand Strauss.



















I don't have the dates of manufacture of these 2 toys, but they look similar as to the type of tow truck that they were modelled from. What I'd like to comment on, is the nature of the construction and lithography of the toys. I had once read that the Marx company once had used discard metal from other companies to make their toys. As such, perhaps there was either a shortage of materials or they could save money in this manner. Of course the paint or printing was on the inside.

When you start to compare the 2 toys, you can see (in my opinion) that more money would have been spent on the Ferdinand Strauss toy.

1. There is more lithography on the Strauss as compared with more solid colour painting.

2. The Strauss toy is painted all over and more thoroughly. look at the underside photos to compare.
The Marx toy has extensive surface rust.

3. The wind-up mechanism is covered on the Strauss toy, compared with the Marx toy.
I don't know if that was for safety or cosmetic appearance, but this would of course cost more in labour and materials.

4. The Marx toy  has 6 wheels, while the Strauss toy has 4.
However, the Strauss toy  had the better lithography (more colours)and is finished on the inside. 

5. The Marx toy has small hubcaps on the wheels.

6. The Strauss toy is larger in size.

7. The Strauss toy has more extensive design which would have required more cutting and shaping on the large presses of the time.

I don't know what the original costs of the toys were at the time. And both companies were quite successful. In the end, the Marx company outlasted the Ferdinad Struass company, and at one time Mr. Marx even made the time magazine cover. His company at one time was making almost 1 in 4 toys made in the U.S.A. So although the Marx toy company toys might have been less costly both in production and at the marketplace, the company certainly would have been on the top 50 toy manufacturers of the last century.

Thanks for dropping by,
and as always, 
have a great part of the day,
wherever you may be.
Stacey
toysearcher@gmail.com